Actual TFT display settings files for NetDCU8

      Hello,

      in general you can use any file provided for TCG057. The only important difference between "newer" and "older" boards is the registry path (refer Device Driver Dokument). Newer and future boards always use HKLM/Drivers/Display/LCD/ as path older board use HKLM/Drivers/Display/<CPU Manufactory>.

      Following should work for NetDCU8:

      Source Code

      1. reg open \drivers\display\samsung
      2. reg create key mode100
      3. reg set value name string "Kyocera TCG057VG"
      4. reg set value EFW dword 1
      5. reg set value BFW dword 16
      6. reg set value msignal dword 2
      7. reg set value rows dword 480
      8. reg set value LPP dword 480
      9. reg set value width dword 115
      10. reg set value height dword 86
      11. reg set value contrastenable dword 0
      12. reg set value contrastvalue dword 0
      13. reg set value type dword 6
      14. reg set value config dword 0x00700000
      15. reg set value columns dword 640
      16. reg set value PPL dword 640
      17. reg set value HSW dword 96
      18. reg set value bpp dword 16
      19. reg set value lcdclk dword 25
      20. reg set value VSW dword 16
      21. reg set value BLW dword 60
      22. reg set value ELW dword 40
      23. reg set value EnableCursor dword 1
      24. display mode set 100
      25. reg save
      26. <enter:>
      Hope this helps.
      F&S Elektronik Systeme GmbH
      As this is an international forum, please try to post in English.
      Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.

      Post was edited 1 time, last by “fs-support_ZU” ().