Every time I try to connect with DS5 + Dstream to the board while in u-boot, it reboots.
Any advice how I can do bare metal debugging on your board without reboots?
Disconnect pin 7 on the JTAG connector.
The DStream manual marks this pin as NC but it is used on the DStream.
On the efus this pin is also used as a reset input.
If you can connect in nboot then debugging works.
You also have to make sure that the security functions of the i.MX6 are disabled, because they can also prevent debugging.
F&S Elektronik Systeme GmbH As this is an international forum, please try to post in English. Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.