eMMC U-Boot

      By default, the mmc command uses the first mmc port, which is the external SD card slot. So you first have to switch to the eMMC device. If eMMC is available as mmc 2 (where mmc 0 and mmc 1 are the external SD card slots), you have to say

      Source Code

      1. mmc dev 2


      first.

      BUT, unfortunately in the current U-Boot from the fsimx6-V3.0 release, eMMC is not yet activated. Which means there is no such mmc 2 device. Of course we have implemented this in the meantime, but there is no official release yet. We are currently about to prepare the next release. It will only be a few more days, around middle of september.

      Your F&S Support Team
      F&S Elektronik Systeme GmbH
      As this is an international forum, please try to post in English.
      Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.