Lcd Parameter for different display.

      Lcd Parameter for different display.

      Hello , I need to connect a different lcd display to the NetDCUA5 board.
      Where I need to put all the information?
      I have this file give me from distribuitor of Lcd.

      Source Code

      1. reg set value name string "1280x120"
      2. reg set value EFW dword 3
      3. reg set value BFW dword 3
      4. reg set value msignal dword 2
      5. reg set value rows dword 120
      6. reg set value LPP dword 120
      7. reg set value width dword 115
      8. reg set value height dword 86
      9. reg set value contrastenable dword 0
      10. reg set value contrastvalue dword 0
      11. reg set value type dword 6
      12. reg set value config dword 0x00300000
      13. reg set value columns dword 1280
      14. reg set value PPL dword 1280
      15. reg set value HSW dword 3
      16. reg set value bpp dword 16
      17. reg set value lcdclk dword 11
      18. reg set value VSW dword 3
      19. reg set value BLW dword 54
      20. reg set value ELW dword 54

      Thanx
      Alessandro.
      Hello,

      please refer device driver document chapter LCD Driver . fs-net.de/assets/download/docu…BRID_DeviceDriver_eng.pdf.

      You have to store the driver setting into the WCE Registry. To edit registry e.g. use "ndcucfg". An instance of this tool runs on the debug line (if debug output is disabled:). You can also launch it on any shell (lelnet, cmd).
      F&S Elektronik Systeme GmbH
      As this is an international forum, please try to post in English.
      Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.