A little question about cemgrc

      A little question about cemgrc

      Section 3.1 of NetDCU8_FirstSteps_eng.pdf says that I don't have to start cemgrc on the netdcu8 to establish a connection in embedded vc4. But this doesn't work with my board. I have to start cemgrc, then sometimes it is working, but sometimes not.

      Also debugging an application is unstable, sometimes the connection gets established, sometimes I have to start cemgrc plus cmd line.

      What wrong with my board?
      google.com

      Post was edited 1 time, last by “alierainy2018@gmail.com” ().

      Hello,

      before debugging via Ethernet you have to start "cemgrc" with the corresponding command line. As far as i remember you are requested to do this by EVC.
      I don't know why your connection is not stable, there are no known issues (and main stream Support for EVC++ ended in 2007!).

      Another possibilty for debugging is to use ActiveSync via USB device connection. This is more easy by using VS2005/08.
      F&S Elektronik Systeme GmbH
      As this is an international forum, please try to post in English.
      Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.

      Post was edited 2 times, last by “fs-support_ZU” ().