NETDCUA5 USB host FTDI VCP driver

      NETDCUA5 USB host FTDI VCP driver

      Hello
      I am trying to install FTDI VCP driver on the NETDCUA5
      Configuration Windows CE6, Eboot 1.4, Nboot PVN13, kernel v2.06-Build Jul 28 2016
      ftdichip.com/Drivers/VCP.htm

      But the VCP is not detected and no COM are created
      If I tray to plug an USB stick or a mouse they are detected correctly

      Doing the same installation on NDCU10 was working fine
      2 com are created (COM4 and COM5)

      Could you give me some advice or check if this driver is working on NETDCUA5 ?

      Thanks & regards
      Xavier
      Hello,

      in general (FTDI) VPC on NetDCUA5 should work in the same way as on NetDCU10! But it is difficult to say what is going wrong. Is there any information on the serial debug port? Else i assume we have to debug the usb/serial Microsoft driver layers. Can you provide us your hardware for do that?
      F&S Elektronik Systeme GmbH
      As this is an international forum, please try to post in English.
      Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.
      I am back to the issue I have
      I did several test and was able to detect my FTDI device using
      Eboot 1.5, Nboot PVN14, kernel v2.09-Build Dec 19 2017
      The kernel v2.09 is define as Beta version
      Is there any risk or reliability problem link to this kernel
      is it ok to use the NBOOT 14 and Eboot 1.5 with the kernel 2.09?

      I have one remaining point
      each time I reboot the ndcuA5 a windows popup asking for the FTDI dll
      In NDCU10 after the first detection the device was automatically reconised.
      Do you know how this could be solve?
      One additional observation

      I need to reboot the NDCU to trigger the detection if I plug the USB after the reboot is performed nothing is detected.

      When I copy the dll (ftdi_ser.dll) on startup under /windows then the windows popup asking me for the driver if I enter ftdi_ser.dll then my VCP is created.
      When I copy the dll (ftdi_ser.dll) under /FFSDIK the device is not detected no windows popup and no VCP are created

      Post was edited 1 time, last by “t4science” ().