eMMC device on 6ULL

      eMMC device on 6ULL

      When I compile with all the emmc support I can find, I can see
      the mmc device in Uboot:

      efusA7UL # mmc info
      Device: FSL_SDHC
      Manufacturer ID: 13
      OEM: 14e
      Name: Q2J54
      Tran Speed: 52000000
      Rd Block Len: 512
      MMC version 4.0
      High Capacity: Yes
      Capacity: 3.6 GiB
      Bus Width: 4-bit


      efusA7UL # mmc part
      ## Unknown partition table

      No partitions defined though.
      After booting to Linux, I don't get a /dev/mmcblk0 device node, nor any mention of a /dev/mmc* device at all.

      Any clues to what steps I may be missing?
      Hi,

      yes that is correct you see the stats of the emmc. You can´t
      see the partition table because there is no partition table installed
      yet. Normally you can boot linux and call the tool fdisk:
      fdisk /dev/mmcblkX
      • o -> create empty DOS partition table
      • n -> add new partition
      • w -> write table to disk and exit
      After that you can create a filesystem on you partition
      mke2fs –t ext4 /dev/mmcblkXpY

      Now the partition table and the filesystem is available und you can access emmc from UBoot.

      Why you don´t see the emmc in the /dev directory is another question. Do you have enabled the define
      #define CONFIG_EFUSA7UL_EMMC
      in the device tree?

      Your F&S Support Team
      F&S Elektronik Systeme GmbH
      As this is an international forum, please try to post in English.
      Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.

      Post was edited 1 time, last by “fs-support_PJ” ().