CAN communication on Startkit

And if you use 'T' self test option, do you obtein this information ?
....
CAN controller 0 .....Askipped (No CAN controller)
....
it's normal? because with my application CAN port can be openned but it takes too much time for it (about 10 secs) and I can read some properties like version (259) and name (NetDCUx CAN Device 0|SJA 1000 Chipset) but can not receive and transmit mesages.

Compare your debug and mine, CAN drivers seems to be active in different order or number, it's important ?

about HW, what about resistor that user Marco needed to remove from its board ?

Edit: sorry but I were writing post at the same time, as you write, my CAN controller is not detected OK in auto-test, but SJA1000 is preset on board.

Can be a boot problem ?? I have only flashed kernel (2 times), but not the boot, must I try it, its the same procedure ?

Hello, I have flashed boot too, but same result, I'll ask for RMA to my distributor for return unit.
Thanks

Hello, i suggest it is a HW problem. Nevertheless you may install latest SW befor send the board as RMA i use:
Boot Loader, Version 1.35
StepStone Loader, Version N912
Kernel V1.19

To update all file at once use "edit nbi file" in the NetDCUUSBLoader, sample:

PS. take care and use propen nboot for 64 or 128MB RAM.

Hello,
in download area for NetDCU11, there is no nboot files in Boot folder, only eboot (v1.31 and v1.35).

NBoot is same as for NetDCU9.

Tried with no exit, it must be a HW problem.
I'll send board to F&S.
Thanks