Howto update Bootloader

    Hello,


    how can I update the bootloader from 1.35 to 1.39?
    On NetDCU6 I could type XWB with exact size of the bootlaoder in bootloader menu to upload a new bootloader, but
    on NetDCU11 this XWB command does not exist.


    Thanks a lot in advance,


    Kaiser

    Bets practice is using our USBLoader and updating bootloader via USB device interface.

    Software developer, F&S Elektronik Systeme GmbH
    As this is an international forum, please try to post in English.
    Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.

    Hello,


    I downloaded and instaled the USB-Loader tool.
    After installation I see the red button. After start NetDCU11 while pressing S in Terminal and Command "DU" installation of driver on WinXP ist started. Everything works fine until the end. I get the message "driver not installed successful". No logfile or reason is given. In hardware manager a yellow exclamation mark is visible. When I disconnect USB-cable and connect again, the exclamation mark is gone but red button in USB-Loader tool is still visible. When I double click in hardware manager on "NETDCU11" the message is shown "no driver installed".
    Don't know how I could install the driver properly.
    Someone any hints?


    Best regards,


    Kaiser.

    Please check if you use the right version for your OS (XP x86(32bit),XP x64).
    You can also try to install it manually, for this you find the driver in the NDCUUSBLoader\Dirver\ directory.


    Additional you can use a other USB port .

    F&S Elektronik Systeme GmbH
    As this is an international forum, please try to post in English.
    Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.

    Hello,


    the correct version (x86) is installed on WinXP 32bit.
    I have also tried to install FSBoardUSB.inf manually but without success.
    I have also tried several USB-ports - unfortunately also without success.
    Maybe our virus-scanner blocks something (Kaspersky)? But to test that I have to wait for our EDV-specialists.


    Best regards,


    Kaiser.

    Hello,


    I have to say that it works now.
    I don't know exactly why it works now - I have installed and rebooted the machine several times (with and without virus-scanner) and now it works. The main difference is the name in hardware manager. When it did not worked, the name was "NETDCU11", but now the name is "FSBoardUSB Driver".


    Thanks a lot anyway,


    Kaiser.