Ethernet Status LED

    Hello


    On the PicoCOM4 is it possible to configure in the registry so the Ethernet Status LED defaults to off. I have wired my board with the LED connected to ground and I should have connected it to 3v3 so its permanently on. It would be good if I could change the default setting.


    Regards
    Rod

    This means we can not change the behavior of this pin of the Ethernet controller in the first place. But even if we could change it, the LED won't emit light if the voltage is connected in reverse. After all it is still a diode where polarity matters.

    F&S Elektronik Systeme GmbH
    As this is an international forum, please try to post in English.
    Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.