Hi,
I want to flash WinCE in my armStoneA8 Rev. 1.20... Please help on that ...
Flashing WinCE in armStone a8
-
-
Hello,
and "hm", wath is your problem in detail? At which point do you stall? Did you read already the "First Steps" documentation (http://www.fs-net.de/download/…toneA8_FirstSteps_eng.pdf)?
-
Hi,
Thanks for your kind reply... I had read the first dtep book... When they had told to press "s" to go to NBoot... I also did the same but it is not going to NBoot... -
Hello
did you press and hold "s" while power on?
Or did you enter a single "s"?Can you please post the whole terminal sequence (by copy paste) if the problem persists?
Thanks.
-
Hi,
I kept on holding "s" and there was no response... There was also no response in the terminal too ...
-
Hello,
without terminal output somting is wrong and it can never work!!! You should told us such basic details at first!!!Is your connetion broken?
Your are connected with the right port?
Does the board boot at all? -
Q: Is your connection broken?
A: There is no internet connection getting connected... (No IP address is assigned ... )Q: Your are connected with the right port?
A: Which port u are talking about ?Q:Does the board boot at all?
A: Yes the board boots with the default OS which is loaded... -
Hello,
QuoteQ: Is your connection broken?
A: There is no internet connection getting connected... (No IP address is assigned ... )You have to trigger the download (via Ethernet or USB device) form the bootloader or at least adjust the bootloader for autodownload,. So at first you have to enter the bootloader. You can step into the bootloader using a Serial Connection between WCE Device and PC. Again, do you check the WCE "First Steps" documentation for ArmStoneA8? Else please install NetDCUUSBLoader and check the ReadMe/Howto which will be availabel while installation.
QuoteQ: Your are connected with the right port?
A: Which port u are talking about ?As you can see from the answer above we talking about the "serial debug port". What do you see when you are connected to these port according the "First Steps"?
