Change armStoneA5 from Linux to WEC2013

Hello,

I want change the SW on my armStoneA5 Board from Linux to WEC2013.
First I've erased the Flash from and updated NBoot to V 08 and than I've updated EBoot to V 07.
After Update EBoot and start of EBoot I've to enter the MAC address, but than I became an error message:

Quote

F&S Nand Loader VN08 built Apr 2 2014 08:57:42
armStoneA5 Rev. 1.10
256MB RAM (1 chip) 128MB FLASH (92f1) 500MHz 512kB L2
booted primary image from page 4
serial number not set

Please select action
'd' -> Serial download of bootloader
'E' -> Erase flash
'B' -> Show bad blocks
Use NetDCUUsbLoader for USB download

Bad blocks: None

Erasing.................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................Done

Please select action
'd' -> Serial download of bootloader
'E' -> Erase flash
'B' -> Show bad blocks
Use NetDCUUsbLoader for USB download

Bad blocks: None

Waiting for EBoot, U-Boot, NBoot, M4 Image...
................................................................ 65536 Bytes
................................................................ 131072 Bytes
................................................................ 196608 Bytes
................................................................ 262144 Bytes
................................................................ 327680 Bytes
................................................................. 393216 Bytes
Success, checksum: 0x338d

>>> EBoot image loaded (393216 bytes) <<<

Please select action
'f' -> Save image to flash
'x' -> Execute image
'd' -> Serial download of bootloader
'E' -> Erase flash
'B' -> Show bad blocks
Use NetDCUUsbLoader for USB download

Saving EBoot
Success

>>> EBoot image loaded (393216 bytes) <<<

Please select action
'f' -> Save image to flash
'x' -> Execute image
'd' -> Serial download of bootloader
'E' -> Erase flash
'B' -> Show bad blocks
Use NetDCUUsbLoader for USB download

<-2>Windows CE ethernet MAC address not set.
Enter WindowsCE MAC address (actual ff:ff:ff:ff:ff:ff): 00055108ffd6
MAC address for WindowsCE set to 00:05:51:08:ff:d6
ReadData: failed to read sector (0x480).
ERROR: Flash read failed.
WARNING: MainMenu: Failed to store updated bootloader configuration to flash.

armStoneA5 - WindowsCE Bootloader

:>

Display More

If I now send the WEC2013 Kernel with NetDCUUsbLoader all Flash Blocks from 18 - 1023 will be marked as Bad Blocks.

What can I do or what I've made wrong ?

Best Regards
Joachim

Hello,

any tips for changing SW from Linux to WEC2013 ?

Hello,

any advice to solve the problem ?
Do I've to low level format the flash or something other?

Thank you,
than I will wait for the new version and try it.

Best Regards
Joachim Zeller