Display Mode setting in registry is always reset to 18 after reboot

    Hello,


    I am using an efusA9 DL with WEC2013 on the Startinterface Kit in combination with a NEC NL10276BC13 display.


    I have inserted a user defined display mode (Mode100) into the registry and set the display mode to 100. After rebooting the registry setting for Mode has the value 18 instead of 100. The registry has been proberly saved (the Mode100 key is present and all settings are valid).


    What or who sets the Mode to 18 during boot? If it is EBOOT, how can I configure it not to do so?


    Regards
    Martin Mödlinger

    Try bootloader command "XDE" if it is enabeled ("Y") disable it by enter "N").
    Hope this helps.

    F&S Elektronik Systeme GmbH
    As this is an international forum, please try to post in English.
    Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.

    In the meanwhile i was able to get it working. I installed a newer EBOOT (ebootIMX6SDL_09.nb0) and the XIPiMX6SDL_C8GE_141017.bin. I did a "reset to factory default configuration" in EBOOT and retransferred the file via NDCUCfg.


    (I tried out the mentioned "XDE" command in NBOOT, EBOOT and NDCUCfg, but neither of these tools recognized the command.)