Hello,
what do the ethernet LEDs LED00 and LED01 on PicoCore MX8MN with onboard switch realy indicate? Does Blinker mean link/activity? I cannot find any information about Intel GSW120 ethernet switch on the internet.
Thank you for quick reply.
Best regards,
Daniel
Hello,
LED0 is an activity LED. LED01 is't connected. Please have a look at the hardware documention PicoCoreMX8MM for comparisation.
Your F&S Support Team
Hello,
our new board variants 5 and 6 of PicoCoreMX8MM have 2xLan. In this case both LEDs should be configurable by the kernel driver.
Your F&S Support Team
Hello,
how are the ethernet LEDs linked on your new revision of PicoCore MX8MM-V5-LIN to the KSZ9893R ethernet switch?
With your reference LED1_0 and LED1_1 it seems to be that both LEDs are linked to port 2. I know there is an issue in revision 1.1 but how is it wired physically on Rev. 1.2?
Thank you for reply.
Best regards,
Daniel
Hello,
That issue is solved with the new revision 1.2. You are right, it is still wrong in the HW-Document and it needs to be updated.
In the new version;
ETH_LED_A is connected to LED1_0 Pin (activity LED)
ETH_LED_B is connected to LED2_0 Pin (activity LED)
We are going to update our documents as soon as possible. Thank you for your feedback.
Your F&S Support Team
