Posts by FredV

  • Fixed route

    We have 2 gateways in our network


    Is it possible to create an fixed route in the registry?
    For example trafic to network 192.168.100.0/24 has to route trough gateway 1(10.1.2.253), all other traffic is routed trough the defaut gateway(10.1.2.254)
    .

  • How to add Font

    Hello,


    Can you tell me if it is possible and if how can I add a Font that I can use in my application.


    Greethings,
    Hugo Thijssen
    De Heer Medicom

  • memory leak

    Quote

    "Remote Process Viewer" and the "Remote Heap Walker"


    The Remote process Viewer an Heap Walker are part of the platform builder, this we don't have.

  • memory leak

    Quote

    Do these crash mainly occure when the programm memory is very low?


    The crash occurs when picocom is slow.


    What is low memory 1000KB left or xxxx ?

  • memory leak

    Quote

    What is the amount of free memory after your application has been shut down?


    When the application runs there is still 4900 KB memory left.


    The application uses plusminus 1000 KB.
    When i close the application the memory usage increases !
    Then the picocom starts running slow.


    more info regarding the other items follows

  • memory leak

    when i start control panel -> system -> memory the first time it is for excample 8416.
    then i close all and do the same steps again then memory usage is 8460.
    Every time when i repeat these steps the memory usage increases.


    When i start our application and then shutdown the application the memory is not completly freed.


    Sometimes when our application runs it crashes on the udevice.exe or the replog.exe.


    The device runs slow after shutting down the application.

  • 100 mb full duplex

    Hello,


    On our application we want to design a switch, but for the on board connection i don't want to use ethenet trafo's. The switcht manufacturer advice us to set the interface fixed to100 mb and auto negotiation off.


    greetings Fred