Posts by jesusrcc

Board is: aStoneA5C2-W13
Serial number: 00055108F4C6
It is an starting kit.
It is intended to be used as a replacement of NETDCU8 boards in one of our products, so i changed SO from Windos compact 13 to Windos CE 6 (i am not using last image available in your site but the XIPVYB_CE6Pro_V2.2_151005.bin). I have developed our own tft adapters for 5,6" and 5,7" displays and made some changes to registry related to displays and for using touch controller in the arm board.

Looking at the serial port, boot messages show:
...
INFO: No external RTC found!.
...

seems like it is looking for an external rtc chip and not using rtc inside microprocessor, could upgrading to image to 2.3 solve this problem? any registry setting for internal rtc?

Working with armStone A5 starter kit. Wince 6 image and my own RGB adapter boards for 5.6" and 5.7" displays.
Until now, everything is working fine, but every time i power down the board, date and time are lost.

Is this the same problem as in post:
RTC

i am not using any king of adapter, a 3V battery is directly connected to power conector (Vbat-Gnd pins).

That is what i was looking for... very thank you

Sorry, i did not explained it very well.

It is similar to this: http://es.farnell.com/samtec/f…-mm-smd-20v-as/dp/1667673

in aSt -ADP -EDT1 pdf documment it is the "J2 armStone Connector" (figure 3 in page 6).

Hi!!!

I am developing my own adapter for different displays for armStoneA5 board.
I need to know the exact manufacturer and model of the TTL RGB matching connector used in the aSt-ADP-EDT1 board.
I am trying with connectors from several manufacturers but all of them are a bit taller than the connector used in the aSt-ADP-EDT1 adapter board so i can not tighten the fixing screw properly.