So I rolled back to a previous version and it works ok.
Posts by mark.aitken@mksinst.com
-
-
Hi, Still the same problem, do you have a phone number or email I could use to resolve this quicker?
Regards
Mark
-
Hi I get the same error with a bin file although it is looking for the nbi file in C:\users\admin\appdata\local\temp
-
-
So I deleted the Upper and Lower Filter entries under the Class ID for the driver in the registry and it has started to work.
-
Hi, Yes installed x64 for for a x64 OS, entered DU on the serial terminal but still get error code 10. I've also updated the OS to be latest Win 10. Are there any pre reqs that are needed like Visual C++ runtimes etc?
Regards
Mark
-
Hi, Yes I've tried 2.5.1.1, and I connect my PicoCom1 to a USB port, I get the Yellow triangle saying it failed to load. I've updated the driver by pointing at the driver directory of the NetDCU folder, but I still get the same issue.
Regards
Mark
-
Hi, I've installed NETDCU-USB loader on Windows 10 H2, however, the driver fails to load with Code 10, I've tried to install with the Windows 10 Driver signing check turned off but still no luck. Are there any Pre Reqs for the driver that prevent it loading?
RegardsMark
-
Hi, I'm using an MX8M board on a starter kit, I'm just trying to get it setup to run simple code from the Dev VM and Eclipse. As part of the Eclipse_application_development_eng.pdf file it shows how to edit the SSHd_config, which I have done, It then goes to start the SSH Server, however, when I enter ?etc/init.d/s50sshd start, it fails and on inspection there is no Init.d folder. Any ideas?
Thanks
-
Hi, Thanks for the response, 1.5 has now gone from my folder and 1.4 isn't available either.
Regards
Mark
-
Hi, I have downloaded the Fedora V1.5 VM for use with MX8MM, however, every time I try to import the appliance I get an error of invalid arg. I've also noticed the file is 900mb, but the 32 bit versions are 6Gb, Is there a part of the file missing?