F&S Support Forum

Hi,

yes, I use this layer. Thanks for looking it up, It seems to be okay then.
Qt Support also mentioned to me, that their meta-qt6 layer supports Kirkstone.

Case closed.

Best, Bjørn

Hello,

we did not test QT6.8 with out Kirkstone release yet.
However, the 6.8 branch of the meta-qt6 layer states, that it is compatible with Kirkstone.
https://github.com/YoeDistro/m…be8f3/conf/layer.conf#L38

Did you use this layer to build the qt6 libaries…

Hello,

I have installed Qt 6.8 on the Feodra 36 VM with Y04.2024 release and I have built a core-image-base image with my Qt application, using my commercial Qt license and the Qt 6.8 installation.
However, I researched, that it is better to use Yocto 5…

Hello Gordon ,

A full fsimx93 release will be available this week.
Based on its software status, a fsimx8ulp main release is being prepared and tested.

A main release for fsimx8ulp is therefore expected to be available in mid-September.

For development…

Is there any information about the new release?

We will contact you directly.

Your F&S Support Team

We will contact you directly.

Your F&S Support Team

Hello,

ok thanks for the clarification.
(Quote)

Sorry, my mistake.
(Quote)

What could be a work around for this? We worked previously with the PicoCore imx8mm (+Wi-Fi, serial ports dev/ttymxc1-3) and wanted to switch over to the imx93 using the same…

Hello,

(Quote)

This is a customer specific Variant, so it is not listed on the website.
(Quote)

Yes this is correct. The WLAN chip will drive the RX Pin of the UART so it might come to short circuits if both is connected.

Your F&S Support Team

Hello,

we will start working on the Production Relsease right after the fsimx93 release.
It is planned for Q4/2025.

Your F&S Support Team.