on my PicoMOD1 i see that there is a speaker.
My question is how can i make a beep sound on that speaker (preferably in Visual C#) ?
Thank you for your answers !
PS. sorry for my bad English
on my PicoMOD1 i see that there is a speaker.
My question is how can i make a beep sound on that speaker (preferably in Visual C#) ?
Thank you for your answers !
PS. sorry for my bad English
Hallo,
are you sure that you use PicoMOD1? PicoMOD1 has no audio interface. You can use an I2C sound chip - or for mono-frequent signals - a dio pin for control a speaker.
hi,
thanks for the quick answer.
yes it is a picomod1. the speaker is connected to the dio interface.
can you please give an example on how to make a beep on that speaker.
thank you very much.
Hello,
for access DIO you will finde samples in the sample section of this forum.
Before you can acces DIO you have to fit WCE Registry according your puposes. For this use the "Device Driver" document for the corresponding board.