Hello Everybody,
I am trying to enable output on HDMI port using efusA9 board with starter kit and WEC7. Following instructions from WINCE_FSiMX6_DeviceDriver_eng.pdf document, I have run "display mode set 30" from NDcuCfg. After reboot, there is no output on HDMI, while in registry I have:
!>reg open<LF>
\: HKEY_LOCAL_MACHINE
OK
!>reg open drivers\display\lcd<LF>
\: HKEY_LOCAL_MACHINE\drivers\display\lcd
OK
!>reg enum<LF>
OK -> reg enum key \
00 "Mode30" \
01 "Mode19" \
OK -> reg enum value \
00 "Mode"=dword:30 \
01 "UseBootInit"=dword:0 \
02 "VideoMemSize"=dword:6291456 \
03 "Alignment"=dword:8 \
OK
!>reg open Mode30<LF>
\: HKEY_LOCAL_MACHINE\drivers\display\lcd\Mode30
OK
!>reg enum<LF>
OK -> reg enum key \
OK -> reg enum value \
OK
!>
Does anybody have an idea what I might be missing?
Thanks in advance,
Miodrag Bazdar
