I have just started with this board, the Picocore imx6ul100. I followed the instructions given in the starter kit pdf. I am trying to execute the kernel image, but it doesn’t work. I have downloaded the image through the NETDCU downloader, and when I enable MSD, it says that the drive is not accessible and doesn’t execute the kernel image. After trying for a long time, the USB drive was enabled and formatted, but the data failed to read and write. And now the NBoot itself doesn’t load on the DCU term. I've included the text document with the DCUterm's data or log. I'd like you to assist me in completing this task.
Picocore imx6ul100
-
-
Hi, I have checked everything and I am sure there is no problem with the port but the Nboot itself doesn't load. I would like you to assist me on this.
-
Hello,
does the board go into serial download mode? Do you hear the plugin sound if you connect the board to your PC via USB Device?
If not it would be best if you send in the Board via RMA
https://www.fs-net.de/en/support/serial-number-info-and-rma/
Your F&S Support Team
-
The board doesn't go to serial download mode on DCUTerminal, but I do hear the plugin sound when I connect the board to the PC.
-
Did you also update Nboot or just U-Boot?
-
Just Uboot.. And later I have used mfgtool that's when the problem has started.
-
Please send a mail with your boards serial number to support@fs-net.de and we will send you a recovery tool for Nboot and U-boot.
If this doesn't work please send in your board via RMA.
Your F&S Support Teams
-
Okay thank you