Date and time losed every time board boots

    My NetDCU10 loses date and time every time I remove the power supply and then I apply it again.


    If the board has a lithium batery, why date/time are not sustained? How could I acomplish this (any software or hardware issue)?


    Thanks a lot!

    The backup battery for RTC is located on the Starter Interface, not on the NetDCU10 itself.
    In addition you must set the correct Dip switch to one to enable connection between battery and RTC.
    Please check documentation for Starter Interface.


    Regards


    Holger

    F&S Elektronik Systeme GmbH
    As this is an international forum, please try to post in English.
    Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.