As I started the NetDCU10, I see this on DCUtermi on Port COM1:
Code
- <21><85><1><19><1><1><1><41><19><21><85><1><19><1><1><1><41><19><19><3><65><33><1><21><21>k<3><65><33><1><21><21><1><33><11><65><67><33><65><65>{<5><21><67><65><75><19><3><35><1><1><5><21><67><65><75><19><3><35><1><1><1><5><1><5><1><1><1><5><1><5><1><5><1><5>m<1><17><1><69><3>m<1><17><1><69><3><11><11><65><11><1><65><1><1>{<1><65><1><1><5><75><35>m<1><1><19><67><35><3><5><5><5><5><1><35><35><83><1><1><9><5><1><81><75><33><65><5><9><1><17><75><35><11><19><17><1>o<85><73><35><43><75><3><3><1><65><1><17><81><21><5><17><83><67><75><9><33><1><21><1><3><1><33><1><17><81><21><65>
I read on “NetDCU10_FirstSteps_eng.pdf†that if I do not see the log, I should do the following:
- Check serial connection
- Check power supply
- Check settings of DCUTerm.exe
- Hit “shift+s†before and while power on NetDCU10 plus command “Oâ€Â.
I did it without finding any solution.
I can not use NDCUCFG. Any suggestions?
Thank you very much in advance for your quick answer.
Best regards,
Jose MATA
IFR Automotive