Hallo,
Does the NetDCU5.2 support a display of 12.1" in mode SVGA 800x600 ?
Regards
Geert
12.1" TFT
-
-
Hello,
yes NetDCU5.2 does support this. You should start with mode1:
Display MoreCode- reg open \drivers\display\SMIVGX
- reg create key mode1
- reg set value name string "SVGA standard display"
- reg set value BFW dword 23
- reg set value EFW dword 1
- reg set value BLW dword 88
- reg set value ELW dword 40
- reg set value LPP dword 600
- reg set value PPL dword 800
- reg set value VSW dword 4
- reg set value HSW dword 128
- reg set value type dword 6
- reg set value config dword 3145728
- reg set value msignal dword 0
- reg set value rows dword 600
- reg set value columns dword 800
- reg set value width dword 115
- reg set value height dword 86
- reg set value voltage dword 33
- reg set value bpp dword 16
- reg set value lcdclk dword 40000000
- reg set value EnableCursor dword 1
- reg set value PhysFrameBuffDraw dword 0
- display mode set 1
- reg save
- reg open \drivers\display\SMIVGX\mode1
- reg enum
PS: For a new design you should use NetDCU9 (follower of NetDCU5.2).
