• Hello,

    in the documentation of PicoCore MX8MM or MX8MN are mentioned up to 8 PWM channels. In the GPIO Reference Card I can see only 2 channels PWM1 and PWM2 and PWM2 is reserved for backlight dimming. Where are the other channels mapped to? I need 3 additional pwm channels for brightness control of a RGB LED. This also can be controlled by software PWM.

    Thank you for quick reply.

    Best regards,


  • Hello,

    both CPUs offer 4 PWMs each. (s. ref. manual) So it should be a mistake. If you are using or planing to use your own base board it is possible to access PWM3 or PWM4 on b2b connector.

    Please contact for this informations our sales department.

    Your F&S support team

    F&S Elektronik Systeme GmbH
    As this is an international forum, please try to post in English.
    Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.