How to undo suspend?

  • Hello together,


    through an oversight I have pressed the suspend entry in the start menu. The display become black and nothing worked.
    After switch off an on again the display still stays black. I can't start Wince again.
    The last entry in bootloader is:

    Quote


    Kernel read from flash disk started finished in 11000 milliseconds
    Kernel read from NAND
    INFO: OEMLaunch: Jumping to Physical Address 0xA01084D4h (Virtual Address 0x0h)...


    How to start WinCE again?


    Thanks a lot in advance...

  • Hello,
    i cannot see a connection between suspend button and the behaviour of your board! I have already often pressed this ;-(
    However, is it possible for you to step into the bootloader?
    Are the settings valid?
    Can you reflash kernel?


    PS: you can remove suspend button by:
    HKEY_LOCAL_MACHINE\Explorer]
    "Suspend"=dword:0

    F&S Elektronik Systeme GmbH
    As this is an international forum, please try to post in English.
    Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.

  • Hello,


    yes I can step into the bootloader.
    All settings seems to be fine.
    here are the outputs:



    Should I try to flash a new kernel? Or first reset the settings, and if yes which one?
    Maybe the registry is enough?

  • Hello,
    i would try to download kernel again.
    If you reset the settings kernel would also not start any more (launch address deleted). At first sight ervery thing seems to be right!


    PS: you cannot perform the self test. For this test are special terminators are required.

    F&S Elektronik Systeme GmbH
    As this is an international forum, please try to post in English.
    Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.

  • Hello,


    after a complete new install board now starts again. A new kernel flash was not enough. Just after the bootloader options C, N, P, DE the system started again. Don't know why. Byt the way, maybe I found a bug? During installation I had following output:


    Maybe the new bad block caused the problem?
    Anyway - now the suspend entry in start menu is disabled. I don't need it anyway.

  • Hello,
    we found and fix a bug in a driver. According your description above I think this bug may caused the problems you encounterd. Please use information from following link http://www.forum.fs-net.de/viewtopic.php?f=28&t=2781 to prevent the problem.

    F&S Elektronik Systeme GmbH
    As this is an international forum, please try to post in English.
    Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.