Resistive Touch

  • Hello,


    following question: i have a touch Controller (4-wire) with an Adapter and wan't to connect to the Interface. is the Interface always active for signals (i load the calibration tool), cause in every case i dont get a Signal. Note: i'm just loading the Default starter kit Drivers for EDT Display/Touch?!

  • You can configurate the Touch driver over the registry. Please take a look in our DeviceDriver documentation on Chapter 7.


    https://www.fs-net.de/assets/d…BRID_DeviceDriver_eng.pdf


    I think you use the SX865x Touch controler,do you? This controler are enabled by default on the armStoneA5. The settings vor this are described in Chapter 7.1.3.

    F&S Elektronik Systeme GmbH
    As this is an international forum, please try to post in English.
    Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.