Access registry without COM1

  • Hello,


    I have a problem with a NetDCU5A WEC2013. The COM1 is in error and I can't access to the registry via "NetDCU Config Utility" to change parameters COM1. I tested the others COM but it doesn't work.


    do you have another way to access the registry ?


    Thank you very much for your quick response.


    best regards.

  • Hello,


    >>The COM1 is in error and ...
    <<Which error did you detect on COM1:? HW error? So you have to send board as RMA!


    >> ... do you have another way to access the registry?
    << You can ndcucfg also launch on any console. If display works launch "cmd" and enter "ndcucfg". If Ethernet works open Telnet session and enter "ndcucfg". Without Ethernet, display or sereial port you have noch chance to modify WCE Registry:(.

    F&S Elektronik Systeme GmbH
    As this is an international forum, please try to post in English.
    Da dies ein internationales Forum ist, bitten wir darum, Beiträge möglichst in Englisch zu verfassen.

  • Hello,


    I'm sorry but I can't tell you the error because I don't have the NetDCUA5 anymore.


    I tested to access to the registry with Telnet and it's work.


    Thank you very much and a very good weekend.